Is there any concern when you field modify the manifold to be inverted, that the air vent assembly can no longer be snugged up tight to the body of the manifold (like when it was shipped as the non-inverted assembly)? Another way of stating this is: since the air vent assembly has to be rotated to stay in the up-right position it must be loosened from the body of the manifold--leaving a ~0.047" gap between the two. Please advise.
Is there any concern when you field modify the manifold to be inverted, that the air vent assembly can no longer be snugged up tight to the body of the manifold (like when it was shipped as the non-inverted assembly)? Another way of stating this is: since the air vent assembly has to be rotated to stay in the up-right position it must be loosened from the body of the manifold--leaving a ~0.047" gap between the two. Please advise.